Quicksell 2000 USB Printer

[CEDRO]

Hello all!

And thank your Mr. Henny for such a great forum.

My question regarding QS2K, is that if usb printers are supportable, and if not, are usb to parallel adapters compatible?

Thanks in advance.

[Henny]

USB Printers are no problem, just load them as a text only generic, they are fine. I always used the epson TMT88III.

[CEDRO]

Thank you Henny for the reply.

I actually have the same Epson printer that you mentioned. So I should load them as text only under the register 1 configuration, what about the register configuration. I have the register with a like phone cable that goes from the register and plugged into the printer.
Thanks again for your assistance.

[CEDRO]

Here are the screen-shots for the configuration that I have:



I hope that the screen-shots are not overwhelming the forum.

[Henny]

Does the drop down for COM ports show the epson port? Did you install the epson drivers?

[CEDRO]

It shows LPT1 through LPT4, and COM1 through COM8.

And this is the driver that I found: APD_407E

I got it from there: http://www.barcodesinc.com/epson/tm-t88iii-drivers.htm

[Henny]

I believe you will setup a com port, usually 7-9 through the epson driver. It has been years though since I have done that. Take a look, if you cannot figure it out, I will dig out my old manuals.

[CEDRO]

That would be great.

I really appreciate your help.
Thanks a lot.

[CEDRO]

Hi again!

I figured it out, I chose Windows under receipt 1 and printer under cash configuration.

However the printer takes about 12 seconds to print, how can I make it faster ?

[CEDRO]

This is so great.

I figured it again

I changed the font in the printer settings and now it's working much faster.

I hope the info will be of good use to people who face same issues as I did.